REAKTOR COMMUNITY

DESCRIPTION

Addsynite is a polyphonic stereo additive synthesizer with subtractive synthesis qualities. Contains:

- 4 Additive Wave Shapes
____Each With____
- Width Control (for Pulse Only)
- Sync button
- Pitch Glide
- Pitch Controls (Freq Mult, Oct, Semi, Fine)
- ADSR Envelope
- Selectable 2-Pole Filter
- Tremolo
- Split/Add Mixer
- Output to send to Waves/FX

- 2 FX Modules
____Each With____
- SE-IV Chorus
- Micro Space
- Metaverb
- External FX

- StereoScope

- Active Display/Controls
____With____
- Randomize for all controls
- Wave Select (Pulse/Sine/Saw/Tri)
- OSC Off button
- LFO Sync button

____How To Use (General)____
To start off, select a wave from the "Wave Select" menu in 'Active Display / Controls'. Next go to the 'Split/Add Mixer' and turn on any Osc. Finally, go to the bottom right, and in the 'Output' macro, hit the "Waves" button. You should be getting signal now.

____How To Use (FX)____
To start off, select a wave from the "Wave Select" menu in 'Active Display / Controls'. Next go to the 'Split/Add Mixer' and turn on any Osc. Then, go to the bottom right, and in the 'Output' macro, hit the "FX" button. Finally, go up to thw two FX Modules, and select which effect you wish to use. After doing so, you may change the mix, as well as the ouput signal. Play a note, you should be getting signal now.

___How To Use (Active Display)___
This is where you see what is active at any given moment. Here you can see which Osc's of which Waveshape is active, what output routing is in use, as well as the outputting levels from that waveshape. This exists so that while you can't see all the controls of all the waveshapes at once, you can still be notified of what is going on when you are not actively looking at the controls.

Created by
Jonathan Tremblay
SyniteAudio
12/07/2015
v.1.02