Trenne Benutzernamen durch Kommata.
Why dident I think about that! Thanks colB for reminding me about the basics of Reaktor!!!!! Im getting ooold......:-( and stupid......
You are absolutely right! Must be a bug. Weird that its not fixed......................
Im not shure you got my question Im asking how one controls the frequency of an oscillator with much higer resolution.
Shift key make absolute no change.
Hi Is there a way to fine Tune oscillators? Lets say I have a Bento Box OSC that I want to set to a 881 Hz Page 50 in the manual says "For pitch,...
NICE! How do they work? I mean if you want to go from min (left) to higest value (rigth) do you have to turn the encoder several revolutions?
Look at Tensy AD converters..................
As far as i know Faderfox units ar 7bit except for one rotary encoder. The Ø is 15 ,13bits controllers..........So if 7 bit is what you need...
Hi I have posted here a couple of time asking Qs about OSC controllers. I have searched for a flexible High-resolution controller for a long time....
Hi Martin It send integers Im using Reaktor 6.2 I should also say that it dosent continuous values (it dosent repeat last value continuously)
Hi Martin Thanks for the reply Already tried that, and it dosent work. I should also say that my osc controller dont send repeated values.
Hi I have built an OSC controller, its has 13 bit resolution 0-8190 (I know I lose on number.....). Works beautifully on all tested...
Do you know what this Relative 2 complement" do?
The OSC controller is sending single parameter messages and controller in Reaktor CANbe controlled by MIDI (not at the same time of course......)
Hi I good friend of mine have built a OSC controller around a Teensy We are get a totally stable 15bit resolution and it works rely well. The...
Is this not possible? Yes or no?
Can no one answer this...? Well I came up with a solution, but it would be nice to see what others do.......
Hi What do I have to do to "play" the event table just on time and then stop at the rightmost value, and then re-trigger? I need it to be...
Hi How is this done. Would be nice to have a much lower x axle resulution when you manual draw to a table (Im working with clicks) Y axle works...
Hi Here is some words I wrote about hardware for a project studio...... http://www.matsc.net/project_studio.html