1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

Add program change feature to Battery

Discussion in 'Feature Suggestions' started by Steve Dronez, 15/3/10.

Thread Status:
Not open for further replies.
  1. Steve Dronez

    Steve Dronez NI Product Owner

    Messages:
    126
    I would like to be able to chance kits by using my midi controller. Consider a program change feature for the next update of Battery 3. Thanks.
     
    Steve Dronez, 15/3/10
    #1
  2. channelite

    channelite NI Product Owner

    Messages:
    5
    Yes, please add program change via a midi controller. Perhaps next and previous patches could be changed by a keyboard short cut too.
     
    channelite, 15/5/10
    #2
  3. touched1

    touched1 NI Product Owner

    Messages:
    153
    +1
     
    touched1, 21/8/10
    #3
  4. touched1

    touched1 NI Product Owner

    Messages:
    153
    Is there a key command to change kits? I can't believe there isn't....
     
    touched1, 21/8/10
    #4
  5. ew

    ew Moderator Moderator

    Messages:
    21.328
    No, there isn't. It's more than likely due to the large kits- remember that Battery 3 was first released when almost everybody still was 32 bit. RAM purging on the fly would be essential- and problematic as far as audio goes.

    ew
     
    ew, 21/8/10
    #5
  6. touched1

    touched1 NI Product Owner

    Messages:
    153
    Thanks as always for the response, EW.
    My makeshift solution is to leave the cursor hovering over the kit ">" button and tap the trackball button as needed....

    Anyone who has not chimed in about this in feature requests should do so!
     
    touched1, 22/8/10
    #6
Thread Status:
Not open for further replies.