1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

Adding FX with Minimal CPU Usage

Discussion in 'Building With Reaktor' started by eddiehowell, Nov 9, 2007.

Thread Status:
Not open for further replies.
  1. eddiehowell

    eddiehowell New Member

    Messages:
    1
    Dear All,

    Am new to Reaktor 5, but am currently stuck.

    I've created a blank structure, with a sine oscillator all working fine. I'd like the output of the Osc to go into a series of FX units, but for these effects to be done in parallel, and not series i.e. to have FX on/off buttons that essentially route the signal to the FX, instead of processing the signal all the time through all of the FX units.

    I have tried using the Crossfade & Audio routing options, along with a Panel Switch for select -1/+1 to choose whether or not to route to the FX units, but get no change when actually clicking this button (the signal is unprocessed each time).

    Pictures, words, or Instrument files would be equally useful.

    Many Thanks
    Eddie
     
    eddiehowell, Nov 9, 2007
    #1
  2. sowari

    sowari Moderator Moderator

    Messages:
    27,759
    could you upload your ensemble here so we could have a look.

    make you use an Audio Voice Combiner before the FX, and that the FX are mono

    and see picture, where there is an example of a bypass switch.

    sowari
     

    Attached Files:

    sowari, Nov 9, 2007
    #2
Thread Status:
Not open for further replies.