Balancing Volume of Zones

I recorded an instrument with 6 velocity levels per tone. Then I adjusted the volume of the individual tones in contact within each level (adjusting the volume of the individual zones). When all 6 areas were finished, I wanted to improve the transitions to the individual levels and have completely marked a zone area and then corrected something in the Volume input field. My previous changes were gone in the respective velocity level and all volume settings were the same. The whole work was free. Now I have formed a separate group for each velocity level and adjusted the volume of the group. Has worked, however, has become very confusing. Is there an easier way?

happy day
5/8

 

If you have multiple zones selected, any zone volume/tune/pan adjustments are NOT relative, they are absolute, so your old settings will be replaced. You will need to adjust each zone's volume manually one by one.

 

Oh yes Evil, that is, what i have seen in my glassmarble
Only the long way is the right way, but i think, the trick with my group-solution for each velocity-zones works fine.

Thanks for your reply and have a nice evening
5/8