BATTERY 3's Modulation Page.

I am having a difficult time putting the Modulation Router, with all of its properties, in the signal path of my sample's within Battery. I have my kit loaded and I can achieve all of the proper effects from any of the other page's other than the Modulation Page. Yes, I have read both the PDF Manual as well as the physical manual. They both state that I need to assign a property to both the left and right side of the slider. I have assigned a property to both the left and right side of every slider, and nothing happens. It seems like I am missing a step before I even try to route signal to the Modulation Router. It is a wild guess, but it seems like I have to somehow assign the Modulation Page to the signal path. The other thing is that I wish not to use an external controller. I am lost and really want to use the Modulation Page.

I am using Battery 3.03.009 with a 1st generation MacBook Pro.

 

Welcome =)

The modulation router at any time's only affecting the cell that's selected (the one that's constantly lit). Every cell has its oen modulation router.

Does that clear anything up?

ew

 

Nothing happens...

Thank you "ew" for your reply. You are correct that each cell has its own Modulation Page. But how do you activate all of the LFO's and the Envelope Modulator by using the Modulation Slider's for the cell you wish to Modulate? I assign all of the properties that I wish to the Modulation Router Slider's, but the signal goes completely unaffected and I do not understand why. Both the physical manual as well as the PDF manual show a "lit" up tab when activated and I cannot get any of the tabs on either side of the slider to "light-up".

 

Oh... those tabs. They aren't there anymore.
As for the rest of it, they're all working here.

ew