BCD3000 on XP, was working, now nothing at all - need it for Saturday - Help !

hi guys,

I have the bcd3000 with le. I installed it on a fresh XP install, and at first it worked fine, I went to DJ and it was non responsive, I rebooted, and then thankfully it worked.

However I have now booted up today, and nothing ! the bcd is recognised, and is set as bcd3000 asio in the panel as it should be, but again it does not work, hitting the buttons results in nothing !

if i switch it to my onboard sound card traktor runs fine (internally) and if i set it to the non asio bcd sound card the buttons function, but playback is very choppy and stops after a few seconds

can anyone help me ? im going mad, just cant get it working, and i am relying on it for saturday night

 

Choose the BCD as soundcard, close and reopen Traktor again... sounds like the routings are not done. Should be fixed automatically when T3LE is restarted.

 

thanks for the input mike,

afraid it didnt do too much though

when i switched to the DS BCD driver, indeed the next time traktor opened all of the buttons were working on the BCD, however no sound at all, and the waveforms were moving incredibly slowly

i switched back to the bcd asio driver, got sound for about a second, then everything froze up

if i try it with the onboard sigmatel, i get sound then too, but its a bit glitchy - any other ideas ?

i have tried the unit on a mac and it worked fine

 

Do not use the DS driver, only ASIO

 

if i use the asio driver, then I can re-set the programme time and time again, with no change to it at all

 

If you use the asio driver try to reconnect the outputs properly... did you already do that? Main Out -> Out 1+2, Monitor -> Out 3+4