1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

Calibration Problem

Discussion in 'Computer Technology and Setup' started by Decibel9M3, May 26, 2005.

Thread Status:
Not open for further replies.
  1. Decibel9M3

    Decibel9M3 New Member

    Messages:
    1
    I just recently bought Final Scratch 2.0, and I am using Mac OS X Tiger, the newest version. I have downloaded all of the updates. But when I start up Final Scratch and begin to calibrate, one channel does not calibrate properly. The timing on the timecode is off. The record starts too early. I am beginning to think this is a hardware problem. I have tried it on 3 other dj set ups and ended up with the same result. Has anyone else had a similar problem?
     
    Decibel9M3, May 26, 2005
    #1
  2. _Erik.Romero

    _Erik.Romero NI Product Owner

    Messages:
    2

    Did you try different needles??? I was having the same issue at one point. So during calibrating, i clicked on setup and found that one of my needles' levels were off. I tried a diiferent needle and everything worked fine. Try changing up the needles to see if they are worn down or have a bad connection!
     
    _Erik.Romero, Jun 18, 2005
    #2
  3. logicalscience

    logicalscience New Member

    Messages:
    4
    i was warned to wait a few months before installing tiger for this very reason. some programs are not ready for the upgrade

    joe
     
    logicalscience, Jun 18, 2005
    #3
Thread Status:
Not open for further replies.