1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

Cell to Aux

Discussion in 'BATTERY' started by zememe, Oct 20, 2009.

Thread Status:
Not open for further replies.
  1. zememe

    zememe New Member

    Messages:
    7
    Hi, I use Logic 9 and Battery 3 so I can't find in manual how to connect cell to aux. I insert Battery 16xMono and I create few auxes but I don't know how to connect them with cells?
     
  2. Kevin63101

    Kevin63101 NI Product Owner

    Messages:
    298
    I don't use Logic, but what I think you are asking is how to assign a cell (or cells) to a separate channel in your mixer.

    Assigning a cell to a new channel is done within Battery.

    1) Highlight cell (or cells) to assign
    2) On cell tab, there is a drop down just below the volume slider (lower right corner). This drop down is where you assign channels.

    Hope this helps!
     
  3. zememe

    zememe New Member

    Messages:
    7
    Hi, BIG thanks, yes that is solution.

    But :)

    When i assign one cell to 7/8 for example that cell plays on 8 channel, so I add next cell and assign again to 7/8 (hopping to assign on 7 channel) but still both cells are playing on 8 channel. Am I doing something wrong?
     
  4. Kevin63101

    Kevin63101 NI Product Owner

    Messages:
    298
    Not sure. You can have multiple cells assigned to same channel or pair of channels. Usually using a 7/8 channel would be for a stereo sample.

    Guesses: :confused:

    - sample is mono
    - sample is hard panned to one channel
    - channel 7 is not assigned in Logic or volume is down.
     
Thread Status:
Not open for further replies.