1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

Cinebrass and Kontakt 5.1

Discussion in 'Technical Issues - KOMPLETE (Archive)' started by synthnut, Jan 19, 2013.

  1. synthnut

    synthnut New Member

    Messages:
    18
    I haven't used Cinebrass in a while , and have been having issues right along with Kontakt 5.1 since updating to it back in December.....My latest issue is that when firing up Kontakt , and go to the "Libraries" section , it's at the bottom of the list , and says "Browse" instead of "Instruments " ...When I hit the asteric to the right and choose " Open containing folder" I go to the drive where Cinbrass resides , and choose Cinebrass and then OK ....It reads "no library found " ......

    Now if I close out of all that , and go to the " Files " area , and go to the same folder on my samples drive , and choose my "instruments " folder , the sounds load just fine ....
    "files " works fine , but " libraries" does not work at all for me ....I checked the NI Service Center , and my Cinebrass is activated properly ....This is the only program in the "Library" section that I have had a problem with so far ......This is just another issue since I have updated to Kontakt 5.1 ....Haa anyone else had this problem ? ....Thanks......Jim
     
    synthnut, Jan 19, 2013
    #1
  2. EvilDragon

    EvilDragon Well-Known Member

    Messages:
    19,938
    I think I saw the same thing happening to VOXOS over at my pal's machine.
     
    EvilDragon, Jan 19, 2013
    #2
  3. synthnut

    synthnut New Member

    Messages:
    18
    Hi EvilDragon,
    Did your buddy ever figure out how to get Voxos back into the "Library" section the way it's SUPPOSE to run ? ......Thanks.....Jim
     
    synthnut, Jan 20, 2013
    #3
  4. EvilDragon

    EvilDragon Well-Known Member

    Messages:
    19,938
    Nope :(
     
    EvilDragon, Jan 20, 2013
    #4
  5. synthnut

    synthnut New Member

    Messages:
    18
    I put a report in to N.I. .....I'll post my findings .....Thanks, Jim
     
    synthnut, Jan 20, 2013
    #5
  6. Mike Çonnelly

    Mike Çonnelly NI Product Owner

    Messages:
    158
    Not seeing the problem here, Cinebrass and CB pro are showing instruments like they always have.
     
    Mike Çonnelly, Jan 23, 2013
    #6
  7. synthnut

    synthnut New Member

    Messages:
    18
    NI kontakted me , and told me to remove the program , which I did , and then re-install it ...... It's working again ....It's beyond me where it went , but it's back and that's the important thing ..... Funny how NI said that I would be getting a message from the Service Center ....I did not ......I'm thinking that since the Service Center already has Cinebrass down as "activated " that it ignored anything that I did .....?.....It is showing up in the "Libraries " section now ...Things that make you go hmmmmm !.......Thanks to all for the help and supprot .....Sincerely, Jim
     
    synthnut, Jan 24, 2013
    #7