1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

Configuration of M-Audio Firewire Audiophile

Discussion in 'General DJ Forum' started by DJ Lasse, Aug 27, 2005.

Thread Status:
Not open for further replies.
  1. DJ Lasse

    DJ Lasse New Member

    Messages:
    5
    Have patience & understanding with me :)

    Just bought a M-Audio Firewire Audiophile, everthing is ok so far. But how to configure the M-Audio Firewire Audiophile to assign Deck 1 to channels 1/2 and Deck 2 to channels 3/4. I understand that you´re ding that in the control panel under xxxxx. But could some kind person here help me to configure my M-Audio Firewire Audiophile soundcard? My Settings in Traktor 2.6:

    Audio Device: M-Audio FW ASIO
    Master Left: 0: Analog Out 1/2 FW AP [1]
    Master Right 1: Analog Out 1/2 FW AP [1]

    Headphones Left (mono): 2: Analog Out 3/4 FW AP [1]
    Headphones Left (mono): 3: Analog Out 3/4 FW AP [1]

    Thanx in advance

    /Lasse
     
    DJ Lasse, Aug 27, 2005
    #1
  2. Adman_Rob

    Adman_Rob NI Product Owner

    Messages:
    671
    What are you trying to do?

    Use the internal mixer or and external mixer?

    If internal then you need to open the M-Audio FireWire controlpanel. In that control panel you need to route the audio from channel 3 and 4 (you haedphone out in Traktor) to the headphone out on the Audiophile.

    If you wanna use an external mixer then you need to select external mixer in the audio pref in Traktor... then you can select Deck A to output on channel 1/2 and Deck B to output on channel 3/4...
     
    Adman_Rob, Aug 28, 2005
    #2
  3. DJ Lasse

    DJ Lasse New Member

    Messages:
    5
    Thanx!
    Everything worked as you described.


    /Lasse
     
    DJ Lasse, Sep 4, 2005
    #3
Thread Status:
Not open for further replies.