Convert Trigger -> Toggle

Hi,

I want to activate/deactivate a sequencer by keypressing. I check the incoming key via the "Selective Note Gate" Module.

But I only get a trigger signal, the drumtrack gets activated as long as I hold the key. How can I transfer the trigger signal to a toggle, so that I alter the state by keypressing?

thanks for any hints,
Christian

 

There's many ways to do this,

This one is probably not the simplest or the most elegant, but it works here

see the gif attached



bubu from bubuland°

 

In fact the separator module isn't necessary, just take it off, it works too

bubu°

 

thank you, but I found a more simple way:

I use a frequency divider, the Sel. Gate at IN and a const. 2 at N. Works for me, if trouble occurs I will try your solution, thanks again

Christian