1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

Core cells for simple LFO

Discussion in 'Building With Reaktor' started by Jeeboo, Sep 18, 2010.

Thread Status:
Not open for further replies.
  1. Jeeboo

    Jeeboo Forum Member

    Messages:
    39
    Hi there,

    I really feel interested with the core level of reaktor, but still I have no clue where to start to learn well about it...

    I would also like to create a few core cells, that would act as very simple LFO.

    What I need exactly is the LFO in its simpliest state : just a sine with a frequency input and sine output, with amplitude = 1 always (as i seldom use the A input of the LFO built in module, so always have to create constants for).

    Should be a reasonnable starting point?
    I'd like the same with some other waveforms too if possible.

    How could I do that?
    thanks if you can help :)
     
    Jeeboo, Sep 18, 2010
    #1
  2. herw

    herw NI Product Owner

    Messages:
    6,421
    if you want to learn from scratch then start here. At the end of this lesson you will be able to construct a simple core synth.

    ciao herw
     
    herw, Sep 18, 2010
    #2
  3. Jeeboo

    Jeeboo Forum Member

    Messages:
    39
    ok i'll check your link thx!
     
    Jeeboo, Sep 18, 2010
    #3
Thread Status:
Not open for further replies.