D2 Setup with Pioneer DJM 750

Hey guys!

I have just bought 2 D2's.

I just wonder how I set them up with the djm 750.

A usb cable from macbook to mixer - check

How to link the 2 usb cables of the D2 together, so you only need one port? - this one then also goes into the macbook.

And what are the needed settings in Traktor itself to make it work? Output/input.

Thanks a lot After this I can post my a photo of my set-up

 

- You might need to install the driver/tool from Pioneer for your DJM 750
- Configure the Tool to meet the desired Channels on your DJM
- Switch those Channels to USB at the DJM
- Select the DJM as Soundcard in Traktor. If the Tool/Driver is correctly setup you might get asked just to autoconfigure the DJM in Traktor. Just confirm.
- You need one Cable going to the first D2 and then you may use the USB Hub from this D2 with another USB Cable to connect the 2nd D2.

 

Okay, perfect!

Will try that today.
Also, do you perhaps now what audio 'box' you need from Traktor if you use an older mixer? I know they advise A10, but I guess a previous and cheaper version would also work? Thanks man

 

Of cause the A10 is the best Cards NI offers
Sounds crazy but if 2 Faderchannels with each 2 Audiosignals (l+r) are enough for your basic Tasks, then the Audio2 MK2 might be far enough. Its much better than most people would expect. Even if you use Remixdecks you may route them also to these both Channels as workaround without using seprerate ones.