1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

Developing, Snapshots, Crashes

Discussion in 'Building With Reaktor' started by arachnaut, Apr 3, 2010.

Thread Status:
Not open for further replies.
  1. arachnaut

    arachnaut NI Product Owner

    Messages:
    3,106
    I have always found Reaktor to be incredibly solid while running and also quite robust while developing. However, lately I ran into trouble when I started making snapshots in a project under development.

    I did this mostly because there are so many knobs involved and I wanted several default settings. So when I changed a lot of panel settings I would just reset back to some standard. This is especially important because there are quite a few deep stacked macros.

    I ran into all sorts of problems while developing this. Lots of crashes, sometimes I could not even start Reaktor with the ensemble. I lost many hours of work and ended up saving every half hour or so.

    Once I figured that it must be the snapshot data that's causing the problems, and I stopped making snapshots, all these problems completely disappeared.
     
Thread Status:
Not open for further replies.