How do I calibrate my CDJ's with Traktor?

I know this has probably been discussed many times over, but I'm a newbie and I just recently installed Traktor Scratch Pro on my Mac Pro Os X 10.5 and connected everything: Audio 8 (set to Line in) multicore cables are correct, etc.

I also downloaded the latest audio drivers and installed everything.

I have 2 CDJ 800 MK 2 and an A&H XOne 62.

I put the Calibration CD's in and nothing happens in traktor. How do I calibrate the CDJ's? I can't use the CDJ's to control traktor, which was the whole point of this setup.

I can't get to the section where the manual tells you to look at the screenshot of the calibration etc.

On the scope on the CDJ's the CD's are playing just fine.
Any help?

I can play the songs I load into traktor just fine and I can listen to everything, just that the CDJ's are rendered useless right now.

Any help is greatly appreciated...

 

Make sure that the Audio 8 is set to CDJ mode, and not vinyl mode.

 

Hey Skooby,

Thanks for the response. I have it already set to Line in/CDJ. Any other suggestions?

 

Mmmh did you activate the "scratch" mode?

 

calibration is done on program timecode calibration

set scratch pannels to show then reset