How Do You Load An Empty Preset In Reaktor 6 Flesh

Hi,
While I usually just stick with the presets in reaktor I feel compelled to create my own in Flesh. Ive never really gotten a grasp of the Reaktor interface. It's a mystery to me but I manage for the most part so I may be overlooking some basic function.
So far I have found what doesn't seem to work. When I attempt to open an empty preset it jumps back to a named preset. This happens in both stand alone and plugin. I have looked in this forum, read the manual and I have viewed the online videos. Can anyone tell how to accomplish a blank or initiate a preset in Reaktor 6 Flesh?

 

Hi,
I've just tried to load the 'INIT - Flesh' snapshot from the Multitrack bank and it works as expected in standalone. Also tried the same in Maschine browser and that works here, too.

 

Hi Karmik,
Found it just as described. Thanks for helping me out.

 

Hi! (Excuse my terrible english. Google helps me, but I dont't know, if it's O.K. ...)

Unfortunately, the init-preset is not empty!? There are samples loaded. There are also some other pre-settings. I want a blank preset. After loading a sample, I would like to hear only this. Completely unchanged. Or did I misunderstand something.

 

There is a file among the Flesh factory samples called 'Flesh Empty.wav'. It contains 5 seconds of silence.

I loaded the 'INIT - Flesh' snapshot into Flesh, then dragged the 'Flesh Empty.wav' into each of the sample slots, finally saved to the attached .nrkt-preset. Unzip before use.

Listening to the sample unchanged is difficult because the correct settings in Flesh depend on the specs of the sample itself. But you can start approximating by dragging down the volumes of all channels/synths except for the 'Sampler' (central white circle with red central dot) and on its respective 'Sample Engine Page' set the red 'Spectrum' knob (to the right of the Mix knob) to maximum. Then on the 'Samples' page, play with 'Threshold', 'Bars' and 'Steps' settings.