How to change tracks in Cubase?

Guys, please help...

I have two midi tracks and two kore instruments. (Is that correct?)
Or should I make two channels within a single Kore instrument?

 

I tend to use a couple of instruments within Kore. Though if I need a lot of instruments, I'll usually share those between a few instances of Kore.

 

So do I make 3 channels and tracks in cubase and kore?
On my Kurzweil when I wanted to go to the Kurz I simply clicked on a track in Cubase and ~BAM~ the kurzweil did a change to what ever cubase told it.

I think its called "Program Change" and you set Cubase to master and the hardware synth to interpret the Program Change and it would "Bank" change.

Thanks if you can understand me, I need the advice.


---
its depressing because im in track two on cubase and the kore hardware is showing kore midi channel one, if I load channel two into kore and arm a channel in cubase then no sound lol..

I would run this thing over with my car eventually.
---
Im burning KORE right not with a hot curling iron and plugging items violently in and out into the OUTPUTS.

 

Change that instrument to channel 2 in Kore.

Say you create three instruments within Kore, select a different MIDI channel for each (I'm away from my music comps at the moment so can't be more specific - you'll see it there on the page). When you've done that, as long as your Cubase tracks are sending to Kore on the corresponding channels, all will be happy and shiny. It works - honest!