1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

How to control and automate Reaktor from Logic 5?

Discussion in 'REAKTOR' started by Robx, May 20, 2002.

Thread Status:
Not open for further replies.
  1. Robx

    Robx Forum Member

    Messages:
    88
    I am trying to control Reaktor instrument controller messages from Logic 5 to Reaktor 3. I can get to the properties and all in Reaktor but figure out when using Reakor as a VST instrument and hit edit controls it gives me two choices..CC64/CC65(see enclosed picture)..I then went to Reakor and selected for example a filter from Junotek and make it controller #65.Then I moved the fader while recording in the VST controls and it just crashed my computer? Am I doing this wrong? Any way to record automation from Reaktor just via moving Reaktors slides/knobs into Logic?
     

    Attached Files:

    Robx, May 20, 2002
    #1
  2. catskinhead

    catskinhead New Member

    Messages:
    2
    erm i think #65 is used by logic for one of its native automation tasks. i could be wrong but try numbers above this and you might be alright.
     
    catskinhead, Jun 13, 2002
    #2
  3. claudek

    claudek Forum Member

    Messages:
    896
    still no luck

    I am trying to automate Reaktor knobs from Logic 5.5 and if I assign say Logic to 100 (like above photo) ..and set Reaktor slider to 100..nothing happens..Is there any other settings that must be enabled like a SYsex or anything.URGHHH..
     
    claudek, Feb 16, 2003
    #3
Thread Status:
Not open for further replies.