How To Do An "a-to-e" In Core?

Discussion in 'REAKTOR' started by mike_jm, Sep 9, 2017.

  1. mike_jm

    mike_jm Member

    Messages:
    130
    I have a core envelope based on the core envelope library kit as attached.

    I want it to output from its parent core cell in "Event Signal Mode".

    In primary I just need an A-to-E.

    How do I do this in core?

    Thanks.
     

    Attached Files:

  2. herw

    herw NI Product Owner

    Messages:
    5,779
    set the corecell output to event and activate audio events allowed.
    Bild 1.jpg
     
    Last edited: Sep 9, 2017
  3. colB

    colB NI Product Owner

    Messages:
    1,835
    Do you want it to output non-audio events at event rate, or at audio rate?

    Both are possible, and which is appropriate depends on the context.
     
  4. mike_jm

    mike_jm Member

    Messages:
    130
    That does not solve my problem. That outputs audio rate data from the envelope which is much too fast and it is overloading the things that follow in the chain. I still need a primary level a-to-e after this approach to throttle it.

    Isn't there a way to set the envelope itself to event level in core?
     
  5. mike_jm

    mike_jm Member

    Messages:
    130
    I want it to output the envelope data at event rate, ideally as an event level process.
     
  6. herw

    herw NI Product Owner

    Messages:
    5,779
    Bild 2.jpg
    and from outside
    Bild 3.jpg
    If you want to define your own Control Rate (f.i. 20Hz) you can use the macro CR Gen
    Bild 4.jpg
    ciao herw
     
    Last edited: Sep 9, 2017
  7. mike_jm

    mike_jm Member

    Messages:
    130