I built an alternative 'vibe' effect

I built a vibe effect using the crossover and an lfo that sounds pretty sweet! I'll put up a sound clip later on but what you do is...

open a split

open a crossover in the 'b' side of the split

set the freq to ~580 hz

pan the two side of the crossover a little bit (10-15)

set the crossfade on the crossover slightly off (43:57)

open an lfo (sine) and assign it to the crossfade (50%)of the cross over

the split you can use the mix the effect in and out (I like a little dry signal in with the effect)

vary the the speed to taste. I like to set the RK2 pedal to shift between a slow and fast speed.



Enjoy!

 

Cool way of using the crossover- I didn't think to use it like that. Post a tone will ya?

 

hopefully you'll be able to hear this. This is the vibe on a loop I'd recorded earlier. so it's not in the ideal place for a vibe (before an amp) but at the end of the chain you get the idea.

 

This is a good example of what I was saying in the thread:
http://www.nativeinstruments.de/forum_us/showthread.php?t=52994
Someone should be putting all these creative ideas into an E-Book. The content could be pulled from the forum. Maybe I should keep my mouth shut and just do it.