Is it possible to refresh the track ID3 tags?

I've updated all my tracks with a very important information (for me at least), and I stored it in ID3 Tags. How can I tell TSP to read it again, without using the most dumb method possible: removing and then including the track in the library again.

 

25 reads, no replies?
I'm guessing the answer is no?

That's one crappy library manager right there!

 

To get Traktor to update all your Tags you need the enable Consistency Checker in Preferences.

When you close and restart Traktor it will perform the Consistency Check and all tags will then be updated.

Karlos

 

Also if you want to do this with one or few tracks without restarting Traktor you can select them and open the "edit" dialog click "apply" then "OK" and you are done, your tracks will be refreshed.

 

Problem is I wanna do this to ALL my tracks, so opening each one is hardly an option

 

Dude i gave you the correct answer.
Just run Consistency Checker and Traktor will update ALL your tags in ALL your tracks.


Karlos

 

Ok, I read your answer, thanks for that. But Pepe gave another answer and I was replying to him. Didn't get a chance to test the Consistency Checker yet.

 

You can select all the tracks at once by double clicking the collection icon, then right click over them and select edit, it should work, but yeah, the consistency check method is not bad if you don't mind to restart Traktor.

 

Don't mind restarting at all, if it reads the whole library again then I'm set, one time, for good.

 

You dont need to restart.
In the Browser Tree, right-/ctrl-click the TrAck collection icon and select Check
Consistency from the menu.

All in the manual guys..!

Karlos