1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

Kore 2 driver install "Pre installation of the AVS device driver failed"

Discussion in 'Technical Issues' started by chico jones, Dec 20, 2010.

Thread Status:
Not open for further replies.
  1. chico jones

    chico jones Forum Member

    Messages:
    261
    I just got Kore 2 and I'm trying to install. When it comes to install the Kore 2 driver, I get the following message.

    "Pre installation of the AVS device driver failed. Setup will abort"

    Any suggestions?
     
    chico jones, Dec 20, 2010
    #1
  2. ew

    ew Moderator Moderator

    Messages:
    21,328
    ew, Dec 20, 2010
    #2
  3. chico jones

    chico jones Forum Member

    Messages:
    261
    thanks for the fast reply, downloading now
    ---
    The updated driver installation worked. At least I think it did, now I just have to figure out how to use the controller. But basic functions are working fine. Thanks again EW.
     
    chico jones, Dec 20, 2010
    #3
Thread Status:
Not open for further replies.