LFO Sync Rates

Hey people, i'm familar with basic concepts of synthizizers and what they do and how they work, I couldnt tell you in detail the more intricate processes that go on or the math behind it but still I am able to build ensambles to a certain degree.
At the moment I have built a 3 Oscillator instrument that is affected by a 4 pole filter and created an LFO to modulate the Cutoff control of the filter which all works fine, the question I have is does anyone know how to create sync rate controls which allow you to sync the LFO to 1/4, 1/16, 3/16 etc?

I was thinkin perhaps of creating a button and setting its value to the appropriete decimal point conversion of the fraction (0.25 = 1/4) then adding in a switch so I can switch between multiple buttons and then hook that up to the frequency input of the LFO (basically being able to switch between different decimal point settings with the click of a button), I attempted to do this and nothing happened so this is where I am falling flat.

If anyone has any insight into this and can help then that would be greatly appreciated.

I am quite new to Reaktor but im getting to grips with the operations quite quickly but it's just these few minor blocks that are holding me back.

Thanks again and I look forward to hearing what you guys think.

Cheers.

 

Hey Phoenix I am pretty sure I would use the list module. Maybe thats not exactly what you need but it sounds close..
Just append as many entries as required. Then under the view properties you can choose if you want the list as buttons.
cheers,
Tristan.

 

maybe these screenshots help?

this is CList's synced LFO.

sowari

 

Thankyou very much guys, those screenshots were extremely helpful
Appreciate the help.