1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

loading presets problem

Discussion in 'PRO-53' started by scaryjapan, 23/9/08.

Thread Status:
Not open for further replies.
  1. scaryjapan

    scaryjapan NI Product Owner

    Messages:
    11
    Hi, I made tons of presets in standalone mode, saved them all, but now in my host (cubase4), I try to load the bank and only some of the presets show up, yet again in standalone they all load.

    This is one of my favorite synths but the loading and saving is pretty badly implemented. Thanks a lot.
     
  2. iaminsane

    iaminsane Forum Member

    Messages:
    75

    NI's following of the file/bank/program metaphor from the original is pointless. The prophet 5 was developed in 1978 for goodness sake! If Sequential Circuits had the ability in 1978 to implement a more user friendly preset mechanism, they most certainly would have. Thirty years later, it is just stoopid.

    I can't understand why this was done with the pro-53. FM8 doesn't mirror the limited user interface of the DX7.

    Loading and saving is insanely difficult. It's too bad, it's a very cool synth, but whenever I give it a try, I give up within 10-15 minutes in frustration.


    good luck with it...
     
  3. engineerjoel

    engineerjoel NI Product Owner

    Messages:
    75
    OMG! On a MAC, Command-Clicking on the preset number window actually brings up the entire patch list. You can easily see Patches 111 thru 888.
     
Thread Status:
Not open for further replies.