logical Q when using LFO as source for AM (newbie Q)

Hi there,
I want to use an LFO as a source for amplitude modulation on a simple oscillator. It works fine, using an add module and adding up the desired AM level with the Gate sig (the output of ADD connected to A of LFO).
Of course the problem is that when there is modulation the osc continues ringing as the amp level is unequal to 0. I tried an A to G module which is fine, the sound stops when ever the MIDI key is released. However any changes in modulation level is not updated before a new trig signal appears, i.e. a new key is played.
Any idea how I can have realtime control over the level of amplitude mod and still the oscillator stops at a note off event?
I added a screenshot of the structure.
Thanks
Jurgen

 

I'd try multiplying Gate and Ampl and putting the mult output in 'A to Gate' In: each time you move the Ampl knob, In receives a new event and G is updated; there are other solutions as well, but they would involve more changes to your structure.

 

Hi,

I'm new to Reaktor as well. I had the same problem last week and found this to work ok.

Regards