Loop Display Should Update When A Stored Loop Is Activated

If you activate a pre-stored loop, the display doesn't change to show the stored loop size. That way, if you were in a sub 1 loop before, and want to change the size of the stored loop you've just activated, there will be a phase sync issue, since the encoder will modify the loop size starting from the last size used, not the 'actual' size of the stored loop.

I don't think that's a logical behaviour.

To reproduce this, please follow these steps:

- Pick a tune. Go to any point and save a 16 beat loop, as cue point 2. The display, on the s4 will show 16.
- Now go to the begining of the track, and do for example a floating 2 beat loop. The display will show 2.
- Now, jump to the previously stored loop...

What number do you see in the display?
What number makes sense to see?
What happens if you shorten the loop?

 

+1

I noticed this yesterday, damn annoying.

 

Big +1 on this. If I go from a bigger to a smaller loop and then change it with the encoder the loop jumps to the big size instantly.

 

+1

 

+1