Mapping an LED Output for Cue Points

I am having trouble mapping an LED Output on my controller.

I want the LED to be ON if there is any kind of cue point assigned to that CUE / BUTTON (cue, loop, fade-in, fade-out) and OFF if there is nothing assigned to it.

Can someone tell me how to map this?

Tried a few things that I thought would do the trick but no luck yet.

 

What controller?
I know that saved Hotcues can have led output, as for fade in/out, I believe once the cue type is mapped, then these also should have led feedback. But I'm not sure how or if the type is assigned to specific colors.
If led is available for a command you should be able to click the add out button. Then adjust the settings as needed.
I have had issues mapping certain controllers, sometimes you have to use the editor for that controller to set it up for the correct midi messages.
I also ran into an issue with a controller in which I had to assign the Beat phase and modifiers to make an output.


You can always go to https://maps.djtechtools.com
Find a mapping for the same controller and look at the commands for similar functions.
One of the ways I learned the most for mapping was just downloading and looking at how the more advanced people had done it.

 

Add Output > Track Deck > Cue > Hotcue x Type

Range: -1 to 5 (-1 = no hotcue, 0 = Cue, 1 = FadeIn, 2 = FadeOut, 3 = Load, 4 = Grid, 5 = Loop)
Midi Range : 0 to 127

With this commands the button lights up, when a Hotcue is set.

 

Thank-you! This info was massively helpful.

 

It does not seem to light up the HotCue LED's on a Pioneer XDJ-RX2. Any idea what I am doing wrong or could do different?

 

Use cue type modifier