Mapping for OHM 64.

Hi I Created a New mapping for the Livids OHM 64. Its something Ive been working on for some months now, constantly tweaking it. There is still room for improvement so suggestions are welcome. Its a modification of Robert Vela's traktor mapping, so you will see some similarities with the layout however I also added a lot more to it. This mapping is a 3 track deck 1 remix deck mapping with full control over the effects. Where decks A and B are your primary decks and C and D are intended as dump to decks, however you should more or less be able to use them to their full potential.

Things to note when reading the diagrams;

-the boxes with blue borders are the modes, pressing these will change the mapping to that diagram.
-the shift button in DJ Mode affects parameters as follows:
(1) all FX on and Deck FX on
(2) wet/dry of loop recorder
(3) master volume
(4) mix to master ratio
(5) tempo fader and nudge for deck C
-capturing from deck B is possible if you hold down "capture A" as well as "cap shift B", both buttons together.
-volume faders and eq's for decks C and D are paired together, this is simple a matter of space and the fact that I don't see a point in a DJ where I'd had all 4 decks playing at the same time.
-to delete cue points hold the Del cue button and then press the cue you want to delete.
-"Load Remix Deck Cells" requires you to be in remix mode and the buttons act as shift buttons. press the load type and then choose your cell.


Download the mapping free here


If you wish to support the development of this mapping please log into PayPal click on the 'send money' tab and forward proceeds to jensdonlin@hotmail.com. Should I get enough support Ill purchase the Ohm-RGB and update the mapping for this controller. If there is enough interest I can also release a 2 track deck 2 remix deck mapping which I have been developing along side this.

Enjoy


Jens.

 

I just found a few bugs and updated the tsi to version 1.1

 

Just tested it out. Will be testing further in the morning.

Seems to do what you have detailed in your diagrams.

Colors are a bit buggy still however.

All around -- GREAT JOB!

 

Cool cheers man,
I can Imagine the colours are buggy, as I own an ohm 64. Which only has blue Led's. If you do update the colours, find any bugs (other than colours) or have any suggestions, let me know.

I do have the 2 deck 2 remix mapping as well however its not nearly as polished as I feel this layout is more preferential.

Glad you enjoy it.

 

that makes sense then. I'll just try to clear out all the LED settings. So that the entire thing defaults to green for the ohm rgb.

It has colors from the old .tsi and looks a bit too messy. Rather have monochrome template..

Thanks again.
-Robbie