Mapping hotcue LEDs to stay on untill deleted!!!

Hi, any help on this would be gratefully appreciated, I want to map 8 hotcues to 8 buttons I'm not using on my x1mk1, the problem I'm having is that the led won't stay on when I am using the button I've assinged the hotcue to! So say I have mapped hotcue 1 to a button on my x1 and then map the (out)command to the same button for the led to come on, if I press the button again the led goes off, I want the led for the button I've assinged the hotcue to say on untill I have deleted the hotcue! Hope this makes sense as I'm really stuck and would appreciate any help I get, thanks again

2 minutes ago

 

(update to my post earlier)I've managed to get the led to stay on when pressing say hotcue 1, what I crnt seem to fathom out is how to get the led to extinguish when I press shift and hot cue 1 which I have mapped to delete hot cue The led temporarily goes out when I press the shift and delete hotcue 1 button , but as soon as my finger lifts off the shift button the led comes back on even though the hotcue is deleted!

lecatzeye, A moment ago

 

How are you mapping the output for the LEDs?

The mapping function you want is 'Hotcue Type'. The value -1 means no hot cue is set, 0-5 are different types of cue points.

So if you want an LED to be on if there's a cue point, just map hot cue type and set the value range to '0' and '5'. If you want an LED to be on if there's no cue point, set the value range to '-1' and '-1'.