Mapping LED colors

Hello, All!
I have a X1 Mk2 that I use for my DVS TS3 controls. I hardly ever use the Hot Cues 3+4, so I've mapped the pitch bends for -/+ in 3/4 respectively and on decks A/B. All good. Then, I learned how to map colors to them, so, to differenciate easily in dark environments, I have Lime on pitch bends for deck A and Magenta for deck B. All good, too. The issue here is that, every time i open TS3, the X1 doesn't light up the mapped colors. If i go to Controller settings, the mapping is there! Just not being achieved on start up. I need to go to all 4 options and put the selection that they already have set, in order to make the X1 obey and light up what I want, how I want. Exporting mapping and then importing also didn't work. It's something I fix in 10 secs every time I start Traktor, but it sucks that after achieving the end result on my own, the easiest part is yet to be done.
What am I missing, Guys?
Thanks in advance!

 

You need to select the X1 for the In and ut ports. In the picture no device has been assigned to the mapping.

 

It sounds like you want the LEDs to light up permanently, not just when using Tempo Bend. So you should map the LEDs to Send Monitor State, which should make the LEDs light up when you connect the X1.

 

There is, just not showing on pic because the x1 wasn't connected. If I connect it, it shows.

 

They are permanently on even if I don't press them, which is the intended. They're just not on on start up!! :/

 

Where is that option "Send to Monitor State"?

 

It's under Add Out... > Global.

 

Hey! This didn't work either

 

Still no help