1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

Mapping Reaktor

Discussion in 'REAKTOR' started by JackAstro, Jun 28, 2013.

  1. JackAstro

    JackAstro New Member

    Messages:
    13
    I created a Reaktor ensamble. I have Reaktor running as a plug in in Maschine. I cannot make the Maschine knob map to a parameter in Reaktor.

    I tried:
    1) In Reaktor, alt-click and select MIDI & OSC Learn then turning the knob in Maschine.
    2) In Maschine, alt-clicking the knob and selecting Learn Plug-in Parameter then turning the knob in Reaktor.

    Do I have to do something to make Reaktor mappable?
     
    JackAstro, Jun 28, 2013
    #1
  2. Moujik

    Moujik NI Product Owner

    Messages:
    1,761
    Have you sorted & compressed the automation IDs?

    Also, have a read of the Reaktor Automation.pdf in your documentation folder.
     
    Moujik, Jun 28, 2013
    #2
  3. magneson

    magneson Forum Member

    Messages:
    333
    Check your MIDI settings. Midi I/O has to be enabled in Maschine from Reaktor, and in Reaktor from Maschine.
     
    magneson, Jun 28, 2013
    #3
  4. sowari

    sowari Moderator Moderator

    Messages:
    27,759
    this.

    to clarify, the IDs of the knobs/faders have to be between 0 - 127.

    sowari
     
    sowari, Jun 28, 2013
    #4
  5. JackAstro

    JackAstro New Member

    Messages:
    13
    Yes, that was the problem. The IDs were up past 300. Thanks everybody!
     
    JackAstro, Jun 30, 2013
    #5