mapping the jump to start!

hey ...is there a way i can map the 'jump to start' ...its no there on the mapping section!

or do i have to just save it as a cue and use hot cue jumps .....
i would prefer the jump to start because sometimes when your in between a track CUE the wrong point and you want to start from start and want to jump to start....how do you do that? for a new track? and not a one where you've stored HOTCUES...

 

what version of traktor ?

 

2.6! the latest updated TRAKTOR!
---
and ALSO I had a problem connecting my audio 10
in traktor....in preferences,...output master should be main right ..main left..but output monitor comes as 3.deck A left..4.DECK A right...until 10.DECK D RIGHT ....what do i choose
i tried all combination ...from 3 to 10..when i choose main let for main right.,,,my main speakers don't playback!


please HELP ,

cheers

 

i dont have traktor open right now, but mapping to get back to the start it's something like:

seek position > reset

 

thanks DJ FRESHFLUKE..it works..cheers....any idea on my audio interface doubt i've mentioned above!

 

you'd have to give way more information about the setup you're trying to achieve.

 

hey i got my TRAKTOR SCRATCH FROM SINGAPORE...well my tractor scratch got registered and I'm using it ...bit my AUDIO 10 is not getting registered...it says invalid serial number...but my tractor shows the audio 10...but every time i open my audio 10 in traktor it says please choose and select audio device...i have installed all the new drivers! but then once i install again it works fine till i open it again the next time...even when it is there...i have all the outputs pre configured...
1-main left
2- main right
3- DECK A LEFT
4- DECK A RIGHT
5- DECK B LEFT
6- DECK B RIGHT
7- DECK C LEFT
8- DECK C RIGHT
9-DECK D LEFT
10-DECK D RIGHT

so i don't have any output left for my OUTPUT MONITOR ,,...i TRIED ALL CONFIGURATIONS...so PLEASE TELL ME WHAT TO DO ABOUT MY REGISTRATION SERIAL KEY AS WELL

 

You don't need to register the hardware to make it work. If you would still like to have it registered you can contact registration support and they can sort you out. Links in the support area of the website.

I would try uninstalling (full uninstall) and reinstalling everything again. Make sure you don't have any hardware plugged in during the installation.

 

well i re installed it again...so I'm back to before where the output monitor is as shown..i have attached a picture so you can see and tell me what to do for my output monitor.,,,i have tried all the combinations...

 

Good question. I am not familiar with the A10. On the A8 I think the headphone output was channel D. You are set to internal mode so you only need 1 pair of outputs for you main out and another for your headphones. Not sure what you meant before about having your outputs pre-configured.

 

so how i do i get this problem sorted..? any ideas? or can you ask other moderators?