1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

Maschine 1.8 & Axiom Pro Hypercontrol

Discussion in 'MASCHINE Area' started by MentalS6k, Oct 10, 2012.

  1. MentalS6k

    MentalS6k NI Product Owner

    Messages:
    22
    Hi there,

    Does anyone know if you can use both Maschine 1.8 & Axiom Pro 61 Hypercontrol in Logic @ the same time.
    I've tried, but find ading the Maschine 'Mackie Control' control surface trips out my Axiom.

    I'd really like to have the two running together as I flit between the two.

    Many Thanks in advance.
     
    MentalS6k, Oct 10, 2012
    #1
  2. Und3rd0g

    Und3rd0g NI Product Owner

    Messages:
    138
    good question! have the same setup
     
    Und3rd0g, Oct 10, 2012
    #2
  3. biest

    biest Forum Member

    Messages:
    46
    There is a Vido on Youtube showing how to use two Behringer BCF2000 simultaneous using Mackie Protocol in Logic on Youtube. Maybe this helps?
     
    biest, Oct 12, 2012
    #3
  4. Komplexed

    Komplexed New Member

    Messages:
    13
    I have them both running fine together over here! Just make sure that in the setup up you assign the specific midi ports for Maschine in the Mackie Control setup! Don't leave them set to any! It seems that that was where I was seeing issues at first! Once I changed it everything has been smooth!
     
    Komplexed, Oct 12, 2012
    #4
  5. MentalS6k

    MentalS6k NI Product Owner

    Messages:
    22
    Thank Komplexed, I'll give that a try. You've also highlight something for me in this, in that I've been using USB midi connections for both devices. So my midi channel setting choices are few inside Logics Controller setup window.

    I'm guessing you're using normal Midi cables. Is this the case with you?
     
    MentalS6k, Oct 13, 2012
    #5