Maschine JAM Controlling Logic Pro X ?

template please.....

 

Have you tried to add the mackie control template to jam and then add jam as mackie device in logic?

Uwe

 

yes, but no success - logic doesn't recognise Jam. I have set only play-record-stop-loop-buttons.

 

Unfortunately I don't own jam so I can't try the mackie template. But I made my own with MK1 and Studio and use it with cubase and it works perfect and transport is the same for every daw and mackie, same midi cc's.

Uwe

 

i own studio too, so i will try. But i think the problem is logic.

 

Do you also own a mackie Control this can also be an issue cause if the mackie is mackie device one the others get added as extenders so transport does not work.

Uwe

 

https://www.native-instruments.com/...ntrol-mcu-parameter-id-codes-template.266581/

Maybe this helps with midi note numbers

 

yes - thanks for the link; i googled it just a few minutes ago.
I think i have got it.
I am using Template Mackie Control light as start and choose as controller setup in Logic MCU pro.

The problem was the last two days that the output port of the setup was always off.
But i solved it by choosing Maschine MK3 first. Now i can choose Jam as output port. Then i chose MCU pro again and deleted Maschine MK3 setup.
Now i can always use MCU pro.- finally

I am creating a template for Logic now.

 

Cool and good luck with the template