1. Please do not install macOS 10.15 Catalina yet, as Native Instruments software and hardware products are not supported under macOS 10.15 yet. For more info, please go HERE!
    Dismiss Notice

Maschine > Midi > Ableton

Discussion in 'MASCHINE Area' started by thegarner, May 28, 2009.

Thread Status:
Not open for further replies.
  1. thegarner

    thegarner New Member

    Messages:
    8
    Sorry, I would have thought this would be simple but for some reason I can't see the wolf for the trees.

    Trying to do a simple mapping in Live 8 with Maschine - assigning 8 knobs to the DJ master channel effect rack. Used Controller Editor set up a new template, set one page of knobs to CC 22>29. Back into Live, into Midi map mode, wiggle knobs but it's not receiving anything.

    Should this work? Is there something glaringly obvious I've missed.

    Also, while I'm here. Should the behaviour of a pad in pattern mode be hit once for on, hit again for off? Because that doesn't seem to work. To stop playing a clip I need to hit a blank spot, is that correct?
     
  2. ifgy

    ifgy Forum Member

    Messages:
    43
    Maybe the "remote" of the Maschine-controller isn't on or active in the preferences of Ableton?
     
  3. thegarner

    thegarner New Member

    Messages:
    8
    Awesome, thank you. So simple in the end.
     
Thread Status:
Not open for further replies.