1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

Maschine Mikro Mk2 w/Logic Pro X

Discussion in 'MASCHINE Area' started by mobetta518, Jul 24, 2013.

  1. mobetta518

    mobetta518 NI Product Owner

    Messages:
    100
    Has anyone been successful with using maschine mikro to generate midi notes in Logic Pro X using the controller? I have done the "batch mode" option to single midi notes in maschine, also set the MMC parameters in Logic X Sync menu, then put controller in Midi mode, (shift+F1)...still get no sound from pads when in Logic, unless i go back to software mode, which in turn creates no notes in Logic...any ideas on any steps i'm missing, driver perhaps? Thanks in advance for any suggestions
     
    mobetta518, Jul 24, 2013
    #1
  2. sowari

    sowari Moderator Moderator

    Messages:
    27,759
    i have not got Logic X but:

    why are you setting up the MMC Parameters? you don't need to tough this.

    what are you trying to Trigger in Logic?

    after putting the Maschine Controller into MIDI Mode, you need to use the Group buttons to change the Octaves. Group buttons D or E should select a good octave.

    sowari
     
    sowari, Jul 25, 2013
    #2
  3. mobetta518

    mobetta518 NI Product Owner

    Messages:
    100
    Thank you I will try that.
     
    mobetta518, Jul 25, 2013
    #3