1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

Maschine, Traktor and DJM-900 problem!

Discussion in 'MASCHINE Area' started by Leonaro.Carullo, Jul 1, 2012.

  1. Leonaro.Carullo

    Leonaro.Carullo New Member

    Messages:
    4
    Hello!

    I'm trying running Traktor and Maschine in Windows 7 64 bits.
    Today I plug a DJM-900Nexus and try to sync Traktor and Maschine but a problem appears before, when I open Traktor the program runs perfectly well with the DJM-900 but when I open Maschine it not responding, is blocked.
    Something rare is that I put in the Audio/MIDI settings of Maschine using DJM-900 as audio interface it apperas running but maschine is blocked, when I change the routing to pc audio card MAschine starts to work.

    Someone could help me please?
     
  2. Seb V

    Seb V New Member

    Messages:
    2
    Have u already solved this problem? Do u use the djm 900 interface for machine?
     
  3. Leonaro.Carullo

    Leonaro.Carullo New Member

    Messages:
    4
    I couldn't solve my problem.. Do you undestand what I'm trying to tell?
    I want to use the DJM-900 for Traktor and Maschine..
     
  4. 73*

    73* Forum Member

    Messages:
    355
    With out being familiar with the DJM-900, it sounds like it does not allow you to address more than one piece of software at a time with it. It's probably a limitation of the interface drivers.
     
  5. Leonaro.Carullo

    Leonaro.Carullo New Member

    Messages:
    4
    Do you think is a DJM-900 problem?
     
  6. 73*

    73* Forum Member

    Messages:
    355
    I'm not sure if I would consider it a DJM-900 'problem'. You are likely trying to do something with it that it was not designed to do.

    A hammer isn't a screw driver, but that doesn't mean that there is a problem with the hammer.
     
  7. Scaper7

    Scaper7 NI Product Owner

    Messages:
    725
    My previous experience using NI soundcards (which is the audio IF in DJM-900) is that they are multiclient and should address multi softwares simultaneously. I could be wrong about DJM-900 though. I am curious because this is a possible hardware option for me with traktor/maschine too. Good luck sorting it out ... I imagine this to be a great set up for what you're doing

    is it possible that you might have to release/disengage a pair of stereo outputs in Traktor's audio output preferences to make them available for Maschine?
     
  8. dj rush from vision

    dj rush from vision NI Product Owner

    Messages:
    16
    I will try the same hope it works
    I have macbook pro djm 900 traktor and maschine and x1
    I wanna use 2 channel with traktor controlled by one x1 and the other 2 channels i wanna use for mashcine
    Hope it works
    I will try to route maschine to 2 channels
     
  9. dj rush from vision

    dj rush from vision NI Product Owner

    Messages:
    16
    I want to trigger samples from maschine during my dj mix on one channel and use other channel for maschine for live finger drumming during perform and use other 2 channels for my traktor decks
    Hope will be possible will try