1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE
NOTICE:

Our Traktor Pro Public Beta is available again in our new online community. Join us if you want to try new features.

MORE INFO

MIDI Mapping problem with loop size and FX slot

Discussion in 'Technical Issues (Archive)' started by zememe, Dec 19, 2009.

Thread Status:
Not open for further replies.
  1. zememe

    zememe New Member

    Messages:
    7
    Hi, I'm very new with this DJ software so I don't know much. I have Traktor Scratch Pro setup and I have Korg Nano Key and Pad.

    So I want to use nanopad to activate loop and to set loop size, so is there any possibility to set Loop size to default 8bar, 'cause I don't know how to map 8bar loop and to assign him ti pad. I'm using Loop Set and Loop Size but result isn't good.

    Also I want to use same nanopad to on/off fx slot, so In FX Advance I add Effect Button/Interaction Mode Toggle/Assigment FX Unit1 and MIDI Learn to some pad, but when I hit pad it nothing happens?

    Where is problem?

    Thanks.
    ---
    I found solution for this, I was searching in wrong section, insted FX Advance there is in Mixer section Effect Unit 1 On and Effect Unit 2 On.

    But still I don't have solution for looping?
    ---
    You can delete these posts I found solutions for all problems that I had with mapping.
     
    zememe, Dec 19, 2009
    #1
Thread Status:
Not open for further replies.