1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

Midi relative mode?

Discussion in 'KOMPLETE KONTROL SERIES' started by Kymeia, 4/1/22.

  1. Kymeia

    Kymeia NI Product Owner

    Messages:
    6.268
    Does this actually work for anyone? For me the params just jump from min to max and back when I try to use either of the relative modes, only absolute works (but is the least useful musically). My understanding of how relative mode should work is it enables the knob to start relative where the param is set to in the patch loaded, rather than in an absolute position, which would cause the param to 'jump' in the plugin.
     
    Kymeia, 4/1/22
    #1
    • Like Like x 1
  2. Uwe303

    Uwe303 Well-Known Member

    Messages:
    6.942
    The program that receives midi has to support it, in what setup you try to use it?


    Uwe
     
    Uwe303, 4/1/22
    #2
  3. nv

    nv NI Product Owner

    Messages:
    9
    Midi Relative Mode means:
    • for the sender of the midi messages: send the same value repeatedly when turning the dial in one direction and a different value when turning the dial the opposite direction.
    • for the receiver of the midi messages: each time one of those values shows up increases or decreases the current value for that control by 1.
    So, as Uwe303 pointed out, the receiving side also needs to be configured to interpret the received messages as relative mode - assuming that capability exists in the receiving hardware or software.
     
    nv, 6/1/22
    #3