Missing sounds error 2.6.6

I couldn't find a thread to report bugs and I don't know if this has been addressed already (did a search and didn't find it) but in Maschine 2.6.6 I found that if your project is missing a file and you go to locate it...it will replace the sound in Sound 1 but it won't replace the rest of them. Has anyone had trouble with this?

 

Yes this happened to me too. way before 2.6.
I think it is a bug but hard to replicate, it doesnt always happen.
Maschine finds some audio but others stays with punctuation mark.
And i find no way to show the software where actual audio files are. Even if i know where they are..

 

Oh ok...thanks. I thought it was something I was doing wrong because I know this has never happened before.

 

Do you have any idea now what caused this to start with?

 

I am not for sure....I just know in the past if I went to open a project and a file was missing and it asks me to locate it....I would find it and it would find any other slices I made in that same group but it doesn't seem to find them now. All the other sounds are blank.

 

What happened to me is:
maschine cannot find some files, i locate first one but then maschine dont ask others and open project without them. No way to locate, because maschine dont ask them. leaves the pads with p. marks..
happened 4-5 times..
And i cannot replicate.

 

Thought I noticed the same issue. Will try to reproduce later when I get time.

 

Not sure if this is the same problem I had, but I had issues with the 2.6.6 update. Downgrading to 2.6.5 solved the problem. See my post here: https://support.native-instruments....89-Strange-issue-with-Prismatic-Bliss-samples

 

Yea it's the same....I downgraded to 2.6.5 and while it worked....it was too late for me because by the time I discovered the bug I had already opened several projects under 2.6.6 so they won't open in the previous version.

 

I think I may have encountered the same or similar the other day, but not sure...

Try opening the project that had missing samples/sounds again via File>Open to see if it finds them (try a couple of times if necessary). It worked for me.

 

Thanks...I'll try it that way

 

We just released 2.6.7 Hotfix for this:

• Fixed an issue where, when loading a project, it was possible that not all samples would load and no error message about the missing samples would be shown.

It's up on Native Access right now

 

Thanks Mick!! Appreciate it!