1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

MMC control of transport from external device

Discussion in 'Technical Issues - KOMPLETE (Archive)' started by Ed Devane, Jan 17, 2007.

Thread Status:
Not open for further replies.
  1. Ed Devane

    Ed Devane New Member

    Messages:
    3
    I recently got one of those sweet Novation Remote Zero MIDI controllers, and am trying in vain to figure out how to control the start/stop transport controls in Reaktor with it. I know my controller is sending out the relevant MMC messages, but I see no reference to this type of message in any of Reaktor's menus.


    Any ideas?
     
    Ed Devane, Jan 17, 2007
    #1
  2. sowari

    sowari Moderator Moderator

    Messages:
    27,759
    have you set Reaktor to External Sync?

    see picture
     

    Attached Files:

    sowari, Jan 18, 2007
    #2
  3. Ed Devane

    Ed Devane New Member

    Messages:
    3
    Yup.

    I noticed someone else asked exactly the same question about 2 years ago (http://www.native-instruments.com/forum_us/showthread.php?t=11730&highlight=reaktor+mmc)
    and didn't get much of an answer. The program's recieving every other type of message I send to it, the clock responds to tempo changes but I see no way of sending to the start/stop module.

    Doesn't matter, I'll just continue to use the space bar as I've always done. It'd just be handier to control everything with the external controller...
     
    Ed Devane, Jan 18, 2007
    #3
  4. Itay Cohen

    Itay Cohen New Member

    Messages:
    1
    Very importent question,
    I'm trying to get an asnwer too

    What midi code can start/stop?
    (lets use midievent like 144 for note, 40 for note# & 0 for vel., also like 248 for r/t sync.)
     
    Itay Cohen, Feb 22, 2007
    #4
Thread Status:
Not open for further replies.