Need help setting up Scratch Pro! Pleae Help!

My setup is a Stanton T.62 Turtable (only one) and a Vestax PMC-05Pro and I can't seem to get it to work I have the control Vinyl and everything, but I can't get it to work. My Audio 8 soundcard was properly installed but it always says there is no Input level etc..

Please help me and yes I know my setup is pretty bad, but i got it for free and I want to set it up!:angry:

 

Please, no need to crosspost...

 

Not sure if this is the issue but make sure that your Audio 8 is in phono mode and not line. This is done under the Audio 8 settings program that is installed along with the Traktor software. You can also quickly check the mode your running in by looking at the lights on the box itself.

 

Oh thanks man I'll try that and let you know if anything changed

Edit: It still doesnt seem to work... anything in Traktor I should look for like the input stuff or anything?

 

Have you gone through the setup stages in the manual? If so at which point are you getting to where it just isnt working?

 

Yep, there is a setup guide... can't really advise much apart from follow that unless you can be a bit more specific. Just to confirm, you have Traktor SCRATCH Pro?

 

I have gone through the setup guide, and yes I am using Traktor SCARTCH Pro and just the Timecode on the vinyl will not work, everything is plugged in and when I put on the Timecode nothing happens and I have tried going into preferences etc..

 

OK - the little arrow under the deck header - you've selected scratch control?
---
Sorry if I'm teaching you how to suck eggs - I've sucked enuff in my time

 

some screenshots could be helpful, of the GUI and the audio setup prefs etc.