1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

no send level in battery 3

Discussion in 'BATTERY' started by biotech, Jun 4, 2010.

Thread Status:
Not open for further replies.
  1. biotech

    biotech New Member

    Messages:
    13
    hi!

    i ve got the problem that my cells in battery 3 sends no signal to the effects master.
    there's no signal on the send of the cell.

    any idea?
     
    biotech, Jun 4, 2010
    #1
  2. ew

    ew Moderator Moderator

    Messages:
    21,328
    Are the effects turned on in the master? Are you using full velocity?

    ew
     
    ew, Jun 4, 2010
    #2
  3. biotech

    biotech New Member

    Messages:
    13
    delay and reverb in the master section are turned on.
    i've tested with full and curved velocity..... no signal :confused:
     
    biotech, Jun 5, 2010
    #3
  4. tlennon

    tlennon NI Product Owner

    Messages:
    469
    If you have routed the cells to any output other than master outs, it will bypass the master effects. If not, make sure that your send knobs on the chan and return knobs on the master are up.
     
    tlennon, Jun 5, 2010
    #4
  5. biotech

    biotech New Member

    Messages:
    13

    thanks. i ve routed the cells to other output channels.

    would be nice to use the effects with all outputs. ;)
     
    biotech, Jun 6, 2010
    #5
Thread Status:
Not open for further replies.