1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE
NOTICE:

Our Traktor Pro Public Beta is available again in our new online community. Join us if you want to try new features.

MORE INFO

Numark MixTrack Pro II (New Setup) w/channel volume reset to full on startup?

Discussion in 'DJ Controllers' started by Stewart Wright, Mar 22, 2015.

  1. Stewart Wright

    Stewart Wright New Member

    Messages:
    1
    Hi everyone, I have recently purchased a Numark MixTrack Pro II which I have mapped succesfully to Traktor 2.7.1. There is only one thing I can't figure out... If I turn both channel faders all the way down and start Traktor, the software volume display for the channels is reset to full which results in a track being audible even though the master volume knob and channel faders are set to 0??? Raising each channel fader for each deck just a little resets the volume display to match the hardware position? This occurs before loading a track into any deck.

    If I forget it means when I'm cueing up my first track it plays out at volume even though all hardware is set to zero.

    I have tried reset the deck and mixer but it does not make a difference. If anyone else has experienced the same thing and has a solution please share :) Cheers, Stew
     
    Stewart Wright, Mar 22, 2015
    #1