Numark Omni Control master and headphone output routing problem

Have you tried using the PFL button - you want it pressed for the deck you are listening to through the headphones. Turn the PH mix knob to adjust the balance of how much output from each deck you're hearing over the headphones.

 

Hey Deakin13,

In fact, my issue turned out to be unique to the output routing. I've used the omni for almost a year and am familiar with the cue/pfl buttons. When I upgraded to 1.2.6, I noticed that not only did I have to delete all old Traktor files but my controller's outputs (1/2) were now specific to 1-mixer and 2-monitor. Very strange as there is no documentation about this, and with Traktor 1.2.1, I had used both output 1 and output 2 for connecting to a mixer. Mystery!

Thanks for your response!

 

Hi,

I've bought the Numark Mixtrack and i have the same problem as deakin13 since i can't differentiate what i hear in the master channel from what i want to pre-listen in the cue channel. I've read your pfl button solution but i must be getting blind because i can't seem to find that button in Traktor Le 1.2.5, could you please locate it for me? And another thing, why is the view and tick button with switched functionalities?

By the way, i'm using an usb tascam us-144 mkII soundcard. My output routing is like this (i'm not sure if it should be this way):

Mixing Mode: Internal

Output Monitor:

L - 3: us-144 mkII digital out L
R - 4: us-144 mkII digital out R

Output Master

L - 1: us-144 mkII analog out L
R - 2: us-144 mkII analog out R

I'm using windows 7 64 bits.

I would greatly appreciate if you could help me solving this.

Thank you.

 

i have had this same problem with my omni! just reinstall the drivers for the controller. i also lost my master but reinstalling driver fixed that to