1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE
NOTICE:

Our Traktor Pro Public Beta is available again in our new online community. Join us if you want to try new features.

MORE INFO

omni control accident, crossfader not aligned properly

Discussion in 'TRAKTOR PRO / TRAKTOR SCRATCH PRO' started by skawars, Dec 9, 2010.

Thread Status:
Not open for further replies.
  1. skawars

    skawars New Member

    Messages:
    4
    long story, basically quite a substantial amount of liquid was spilled over my numark omni control. after removing the back panel and drying with a hairdryer / radiator overnight it is almost back to normal, apart from the crossfader.

    when i put the crossfader central, it's about 1cm to the right on traktor pro.

    just wondering if there's any simple way or recalibrating / realigning this, or will i have to take it out and maybe clean it?

    thanks in advance
     
    skawars, Dec 9, 2010
    #1
  2. TomDooley0075

    TomDooley0075 NI Product Owner

    Messages:
    3,299
    hi,

    my advice is to clean the fader contacts with special cleaner spray.
    recalibrating is no solution because the control data are not full transmitted now.
     
    TomDooley0075, Dec 9, 2010
    #2
Thread Status:
Not open for further replies.