1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

Please Help

Discussion in 'General DJ Forum' started by Tamar4, Jan 31, 2017.

  1. Tamar4

    Tamar4 New Member

    Messages:
    4
    My controller wont talk to Traktor?
     
    Tamar4, Jan 31, 2017
    #1
  2. dj.fons

    dj.fons Member

    Messages:
    32
    Maybe if you shared a littlebit more info we might be able to help you .
    What controller?
    What laptop?
    Version of traktor ?
    Os?
    What have you done already ?
     
    dj.fons, Jan 31, 2017
    #2
  3. Tamar4

    Tamar4 New Member

    Messages:
    4
    Thank you.
    I have a Hercules DJ Controller steel running off of hp laptop with windows 10
    Numark DJIO
     
    Tamar4, Jan 31, 2017
    #3
  4. Tamar4

    Tamar4 New Member

    Messages:
    4
    I have installed everything and have been using Traktor no problem for a few weeks but now it wont work?
    The only thing I am aware of is that i have taken my laptop away from its place without all leads etc
    I have replaced all leads and when i boot up i took the usb for the controller out, then back in again but the lights flicker and on occasions the sync lights stay on but still no control of anything via traktor
     
    Tamar4, Jan 31, 2017
    #4
  5. Alexmci

    Alexmci NI Product Owner

    Messages:
    174
    this sounds like a midi problem, when you put your laptop back into your setup did you plug your controller into the same usb port that it was running off previously.
    I only ask this as it is a problem that caused me frustration setting up my Denon SC2000's any time i moved my gear to use outside the house. I eventually figured that it seemed to matter that they had to alway be plugged into the correct port on the laptop or they wouldn't work, although this may have been more due to the fact that my controllers are working on separate midi channels.
    you should first make sure that your controller is recognised in device manager, then start Traktor. Go to preferences, controller manager and in the top window check to see if your TSI file is there for your controller, make sure your midi in and out ports here are assigned to correspond with your controller here also.
    if that doesn't work perhaps delete your TSI and re import it.
     
    Alexmci, Feb 5, 2017
    #5
  6. Tamar4

    Tamar4 New Member

    Messages:
    4
    sorry for the late response but only just been able to try and see if I can get it going again with your advise. Im pretty you are right and will note this using the same port for future reference but its still not working. I'm about try and import and now so wish me luck and thank you for you help as feeling silly being a complete virgin to all this technical stuff but am determined to get set up again and mix away....x
     
    Tamar4, Feb 6, 2017
    #6