1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

pro filter should start below 50 Hz!

Dieses Thema im Forum "Feature Suggestions" wurde erstellt von NIMichi, 20. November 2012.

  1. NIMichi

    NIMichi NI Product Owner

    Beiträge:
    387
    The Pro Filter is not usable for sounds with bass because even if I load it without any frequency adjustment, it cuts all below 50 Hz. Why? Could it start at 20 or 30 Hz?
     
    NIMichi, 20. November 2012
    #1
  2. daverlee

    daverlee NI Product Owner

    Beiträge:
    432
    you ought to try adjusting it. the default is set to a peak band pass filter at 707Hz. change the right-most knob to LPF (low pass filter) and it will pass all frequencies below the cutoff, including 20 Hz to 50 Hz.

    I should ask, what do you want the pro filter to do for you?
     
    daverlee, 7. Dezember 2012
    #2
  3. NIMichi

    NIMichi NI Product Owner

    Beiträge:
    387
    I want to use a sweep transition for a dry and a wet signal, and if it starts at 50 Hz, I cant do that.
     
    NIMichi, 13. Dezember 2012
    #3
  4. Uriel Ohringer

    Uriel Ohringer New Member

    Beiträge:
    20
    I use Split to sweep between dry and wet, if you're using the Cutoff for dry/wet transition I'm either not getting what you mean or you're using a different definition for dry/wet.
     
    Uriel Ohringer, 19. Februar 2013
    #4