1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

Pro Tools and Dynamo

Discussion in 'REAKTOR' started by ronev, Jan 25, 2003.

Thread Status:
Not open for further replies.
  1. ronev

    ronev Forum Member

    Messages:
    39
    As some of you are having trouble w/ PT and Dynamo, the following is from the Digidesign AnswerBase....Hope it helps:

    How do I configure Dynamo and Pro Tools with DirectConnect?

    - In OMS, create an IAC bus for Dynamo (i.e. "Dynamo IAC bus"): In Pro Tools: Setups > OMS Studio Setup. (If it says “Please Find OMS: Desktop > Mac HardDrive > Opcode Folder > OMS Applications > OMS Setups.) Double-click in the IAC Driver. In the field there type in" Dynamo IAC bus".

    - In Pro Tools > MIDI Menu > Input Devices > Enable the "Dynamo IAC bus".

    - In your Pro Tools session create a MIDI track (File Menu > New Track). Assign the "Dynamo IAC bus" as its output.

    - Create a Stereo Aux Input Track (File Menu > New Track). In the Mix Window on the Aux Input channel strip, instantiate the Dynamo plug-in and select the stereo link "Dynamo 1L/2R". In addition, choose any unused input (or pair of inputs) for the Aux IntputTrack.

    - Launch Dynamo.In Dynamo: Menu System > Audio Port > DAE/TDM Direct Connect window. Menu System and MIDI settings…: Select MIDI system in the pop up menu: OMS.
     
    ronev, Jan 25, 2003
    #1
Thread Status:
Not open for further replies.